- Purchased this one because it is slightly cheaper than OEM. I don't think there is much of a problem. I know many people reuse them because they tighten so tightly, but considering the significance of...Olvass tovább
- I am purchasing this because I need it to replace the Slip-on Silencer.The quality is fine and it prevents exhaust leaks well, but it is a consumable item and I would like it to be a little less expen...Olvass tovább
- [How is it used?I used it to replace the YOSHIMURAExhaust System on my WR155.How was your experience with it?It is usable without leaks of exhaust Gas.How did it compare to other products?I have never...Olvass tovább
- Used to replace the Exhaust System on a 2001 D Tracker with an external Slip-on Silencer.OEM Parts No. 11061-1055For late D Tracker and KLX.The size of the Gasket is different from the previous year's...Olvass tovább
- I bought a used SKYWAVE (CJ45A) at a flea market in August 2023, and I felt that the sound was too loud for an OEM exhaust system. I was surprised that the sound became quieter after replacing the exh...Olvass tovább
- At first I thought it was defective because it was too tight, but when I pushed it in slowly and carefully, paying attention to the angle of the frame, it went in like a hammer. It may be a bit expens...Olvass tovább
- [How is it used?Replaced during installation on an XJR400R Slip-on Silencer.I chose this KITACO product because it is a consumable and the OEM price was too high.How was your experience with it?The Si...Olvass tovább
- SizeExactly and working well, no failures and no MOLLET.Olvass tovább
- [How is it used?New CB1100 Exhaust System from OEM to MORIWAKISlip-on SilencerMegaphone Exhaust.How was your experience with it?It was shorter in length than the OEM Gasket, but has not leaked for ove...Olvass tovább
- Arrived 3 days after ordering. The O2 Sensor was left in place, the exhaust system was installed, 3 bolts were removed, and the Gasket was installed. It was as if it was a new car (I don't know!). It ...Olvass tovább
- I bought this to replace my Slip-on Silencer and there are no exhaust leaks, no doubt about it.Olvass tovább
- Required Replacement Items when purchasing and replacing Slip-on Silencer.In most cases, the joint gasket that connects the silencer part to the exhaust pipe part will stick when heated and cannot be ...Olvass tovább
- [How is it used?Purchased to eliminate the gap between the middle pipe and exhaust pipe in order to install a Slip-on Silencer.How was your experience with it?Exhaust pipe and Gasket are perfectly siz...Olvass tovább
- [How is it used?Used on OEM Exhaust pipe and Silencer joint of MainMotorcycle's XJR1300C that had been inspected.The Exhaust System itself is the same as the normal XJR1300, so Gasket could be used no...Olvass tovább
- Purchased to install YOSHIMURA's Slip-on Silencer.Since the vehicle was still new, I thought about reusing the one that had been installed, but I replaced it with a new one just to be safe.It was thic...Olvass tovább
- The quality is good enough even if it is not OEMOlvass tovább
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING