- When replacing the plug of a SUCUB, I purchased Emon's plug wrench (16mm) because the plug replacement is too large to be done with an in-vehicle tool. The plug position of the SCUB is narrow and the ...Olvass tovább
- Purchased for Motorcycle Plugfor Replacement.So far, I've replaced the plug with a simple tool onboard.It's once or twice a year, so I didn't feel particularly inconvenienced.When you work with this p...Olvass tovább
- Most of the time, most of the plug replacement on a motorcycle is done in a small space, so the Universal Type is very easy to use and effective. It is a must have if you are doing your own maintenanc...Olvass tovább
- An ordinary plug wrench will do the job, but I bought this one because it was a bit difficult to turn and handle in a secluded area.In practice, this Flexible works quite well. If you're in an awkward...Olvass tovább
- I bought it for BirdCity's Plugfor Replacement I used Wrench of Straight until now, but it is hard to remove and put in a plug, and it is hard to put in a plug I had a hard time when I couldn't get a ...Olvass tovább
- Since there is only a special tool, the neck of Wrench moves, so it is easy to use where there are angles, deep back. The price was not high, it was good. It's fine but it was cheaper than the nei...Olvass tovább
- Since the engine plug of Honda Today AF61 is in a position where Frame covers and it is difficult for a straight plug wrench to enter the head of the plug, I bought this plug wrench and used it. Altho...Olvass tovább
- I got BANDIT 250, but it's too narrow,A UniversalPlug wrench of type which uses Driver pierced instead of Handlebar does not enter!So, I purchased this item, but Handlebar part is Frameetc. I can ...Olvass tovább
- Because it is cheap, I can not say much luxury, but the Rubber for preventing the Plug's fall was somewhat loose and it remained on the Plug side. I coped with Silicone oil on the plug side. It is...Olvass tovább
- I used it for Plug exchange of ZrX 1200 daeg.Length was just right and I was able to do work comfortably.The Socket section is also solidly attached with prevention of dropping of the plug.Olvass tovább
- The WR250X Plug is located at the bottom of the tank and it is hard to replace it as an on-board tool, but if you have this tool with a special tool you can easily exchange it.There are no losses to h...Olvass tovább
- At first I used the Standard Type Plug wrench, but because the Handlebar part was short and hit the Motorcycle Handlebar, it was very hard to use, so I came to find this for the long Type of Handlebar...Olvass tovább
- I bought it for Plug change of Ninja 250.Strength is also necessary and sufficient, appearance also " - Tool "is feeling and Parenthesis is nice,When I tried to use it for Ninja 250, the Han...Olvass tovább
- This time, I bought it for Plug replacement of ADDRESS V 125s.In the case of Address, since I thought that there would be a difficulty because there was a plug in the place which was very difficult to...Olvass tovább
- I felt that the startability of the Engine was bad so change Iridium plugs. Easy to use and exchanged successfully.Since the Plug position of Address is slightly strange, it can not be exchanged if it...Olvass tovább
- A use price is also cheap, and its Plugs, such as a br>DOHC Single, are satisfactory at Plug exchange of DJEBEL250XC. [ which arrives firmly also by Motorcycle in a deep position ]
Olvass tovább
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING